2. Installation
Removing the Retainers
Retainers are attached to the machine to protect it from vibration during shipment.
- Remove all the retainers. Any that remain may cause faulty operation or a breakdown when the power is switched on.
- The retainer will be required when moving the machine to a different location. Store them carefully so that they do not get misplaced.
WARNING
Carry out these operations before you connect the power cord.
The power turning on inadvertently during these operations may result in pinched hands or other injury.
The power turning on inadvertently during these operations may result in pinched hands or other injury.
CAUTION
Under no circumstances move the spindle unit or table with your hands.
Doing so may cause a breakdown.
Doing so may cause a breakdown.
Procedure
1. Make sure the power cord is not connected.
2. Remove the retainers (in four locations).
Note
Do not connect the machine to the computer at this time.
Be sure to connect the devices as instructed in the procedure.
